# Kconfig - console driver configuration options
# Copyright (c) 2017 Intel Corporation
# SPDX-License-Identifier: Apache-2.0
bool "Enable a super basic telnet console service"
This option enables telnet as a network console service. It is for
now a very basic implementation of the telnet protocol. Currently,
it is basically just a redirection of the Zephyr console through TCP.
It nicely works along with anothe console driver (like uart), twist
being that it will take over the output if only a successul
connection to its port is done.
int "Telnet console port number"
This option is used to configure on which port telnet is going
to be bound.
int "Telnet console line buffer size"
This option can be used to modify the size of the buffer storing
console output line, prior to sending it through the network.
Of course an output line can be longer than such size, it just
means sending it will start as soon as it reaches this size.
It really depends on what type of output is expected.
A lot of short lines: better reduce this value. On the contrary,
int "Telnet console line buffers"
This option can be used to modify the amount of line buffers the
driver can use. It really depends on how much output is meant to be
sent, depending on the system load etc. You can play on both
TELNET_CONSOLE_LINE_BUF_SIZE and this current option to get the
best possible buffer settings you need.
int "Telnet console line send timeout"
This option can be used to modify the duration of the timer that kick
in when a line buffer is not empty but did not yet meet the line feed.
int "Telnet console line send threshold"
This option can be used to modify the minimal amount of a line buffer
that can be sent by the telnet server when nothing has happened for
a little while (see TELNET_CONSOLE_SEND_TIMEOUT) and when the line
buffer did not meet the line feed yet.
bool "Add support for telnet commands (IAC) [Experimental]"
Current support is so limited it's not interesting to enable it.
However, if proven to be needed at some point, it will be possible
to extend such support.
int "Telnet console inner thread stack size"
This option helps to fine-tune telnet's inner thread stack size.
int "Telnet console inner thread priority"
This option helps to fine-tune telnet's inner thread priority.
int "Telnet console log level"
Sets log level for telnet console (for telnet console dev only)
- 0 OFF, do not write
- 1 ERROR, only write SYS_LOG_ERR
- 2 WARNING, write SYS_LOG_WRN in adition to previous level
- 3 INFO, write SYS_LOG_INF in adition to previous levels
- 4 DEBUG, write SYS_LOG_DBG in adition to previous levels
bool "Forward output to original console handler"
depends on UART_CONSOLE
For telnet developpers only, this will forward each output to
original console handler. So if by chance telnet seems silent,
at least things will be printed to original handler, usually
int "Telnet console init priority"
Telnet console driver initialization priority. Note that Telnet works
on application level. Usually, you won't have to tweak this.