# # USB Imaging devices configuration # comment "USB Imaging devices" config USB_MDC800 tristate "USB Mustek MDC800 Digital Camera support" ---help--- Say Y here if you want to connect this type of still camera to your computer's USB port. This driver can be used with gphoto 0.4.3 and higher (look at <http://www.gphoto.org/>). To use it create a device node with "mknod /dev/mustek c 180 32" and configure it in your software. To compile this driver as a module, choose M here: the module will be called mdc800. config USB_MICROTEK tristate "Microtek X6USB scanner support" depends on SCSI help Say Y here if you want support for the Microtek X6USB and possibly the Phantom 336CX, Phantom C6 and ScanMaker V6U(S)L. Support for anything but the X6 is experimental. Please report failures and successes. The scanner will appear as a scsi generic device to the rest of the system. Scsi support is required. This driver can be compiled as a module, called microtek.